MRB-1400NL

MRB-1400NL

The machine is designed for slitting and rewinding a wide range of materials. Slitting of material is done by means of blades or disk knives. The model is convenient to feed a material into a machine and to set the slitting width.

Material paper, tape
Max. roll width on the unwind, mm 1400
Max. roll diameter on the unwind, mm 1000
Roll width on the rewind, mm 50 - 1400
Max. roll diameter on the rewind, mm 600
Linear speed, m/min 300

Order Back to catalog Printable version

The machine is designed for slitting and rewinding a wide range of materials. Finished products: rolls of the required width, diameter and defined layer density.

Machines options:

  • Fixation of the unwind roll to a removable pneumatic expansion shaft
  • Fixation of the rewind rolls to removable pneumatic expansion shafts
  • Edge control system
  • Material length meter
  • Automatic machine stop under the set length
  • Diameter sensor for unwinding and winding
  • Automatic machine stop under the set diameter
  • Automatic pneumatic disk brake system for unwinding
  • Sensors from accidental startup with loose unwind and rewind shafts
  • Automatic control of material tension
  • Automatic density control system
  • Slitting of material by disk knives or blades
  • Two control panels
  • Touch screen on the control panel on the rewinding
  • Rewinding on two shafts
  • Roll handling device
  • Pneumatic guns for pumping unwind and rewind shafts
Roll width on the unwind up to 1400 mm
Diameter of the unwind roll up to 1000 mm
Inner diameter of unwind rolls 76/152 mm
Min. width of the tapes to be slittered 50 mm
Diameter of the rewind roll up to 600 mm
Inner diameter of rewind roll 76/152 mm
Rewind speed up to 300 m/min
Tolerance of the set diameter on the rewind ±2 mm
Tolerance of the set length on the rewind ±0,5 mm
Noise level under the max. speed less than 85 dBA
Max. installed capacity 7,5 kW
Pneumatic pressure 0,55 - 0,6 MPa
Power supply 3 phase, 380 V, 5 Hz